PC-Products 087770 PC-7 Heavy Duty Permanent Repair Paste Epoxy, 1/2 Pound, Dark Grey

Product Information

Because the dispersion is actually a mix of resin and pigment already, it is essential that the correct dispersion type is used to pigment each specific resin type. With their highly concentrated pigment formula, only a small amount is needed to ensure your artwork will be alive with vivid, rich, deep colours. These are a high-quality epoxy pigment paste, so when you want to achieve a more transparent look, you can add even less than you usually would to get the desired opaque finish. Centrecoat Epoxy Paste Adhesive is a thixotropic, solvent free epoxy adhesive ideal for bonding a wide range of building materials to one another e.

Concrete substrates shall be sound, clean and free from dust, dirt, grease, oils, laitance and other contaminants. Our containers make dispersion easy, so you can use only what you require for each artistic concept. Being an epoxy based mould making system, EMP60 is ideally suited for use when making epoxy based end products (like carbon fibre parts or epoxy matrix GRP/FRP). In each of our products you will find more than just a product that performs as intended, you will find a team that stands behind their products.If they're cold, they will feel particularly thick, so the first thing would be to check the temperature you're storing them at.

Use a solvent such as methylated spirit, acetone, rubbing alcohol or lacquer thinner to smooth applied PC-7. Alongside but not touching, make a rounded mound of the same circumference, adding or taking away until the height matches the mound of part A. It’s your go-to repair paste for cracks in metal, fuel tanks (petrol or diesel), water and fuel pipes, plastic switch gear, steering wheels and much more. It is recommended that the hardener is placed first onto the spot-board, flattened a little and the resin placed above; this makes for easier mixing. High “wet grab” or tack of PC-7 Paste Epoxy makes overhead and sidewall work easy without drip or sag.The uncured materials should not come into contact with the skin: the wearing of impervious gloves of rubber or plastic along with eye protection is necessary.